Drilling Enclosures: Avoid This Common Mistake!

This video emphasizes a crucial point for drilling holes in enclosures, particularly when anticipating future additions: use even measurements and consistent spacing from the start.

Here's a breakdown of the key takeaways:

Avoid Arbitrary Measurements: Don't just find the center for a single hole. Instead, use an even measurement from an edge (e.g., 2 inches down).
Plan for Expansion: Position the initial hole strategically (e.g., at 24 inches on a 47 1/2 inch panel) to allow for easy addition or subtraction of even spacing later.
Use the Right Tools: Employ a proper hole cutter, not HSS drill bits, for clean holes in control panels.
Protect Components: If components are already inside, shield them from shavings during drilling.
Debur the Hole: Always debur the drilled hole to prevent injuries during future work.

Measure EVERY Hole in Your Control Panel!

Drilling Enclosures: Avoid This Common Mistake!